Banner Bawah



Listing Details



The Rain Collector is designed to meet the guidelines of the World Meteorological Organization. Rain enters the collector cone, passes through a debris-filtering screen, and collects in one chamber of the tipping bucket. The bucket tips when it has collected an amount of water equal to the increment in which the collector measures (0.01" or 0.2 mm). As the bucket tips, it causes a switch closure and brings the second tipping bucket chamber into position. The rain water drains out through the screened drains in the base of the collector. The collector is designed for years of accurate, trouble-free service. The body and base of the collector are constructed of tough, UV resistant plastic; the tipping bucket pivots on bearings that minimize friction and wear. Stainless steel adjustment screws under each chamber of the tipping bucket allow you to fine-tune the calibration of the Rain Collector. The rain collector comes with an optional metric adapter for converting the rain collector to take 0.2 mm rain measurements for every tip of the bucket. The rain collector comes with mounting holes pre-drilled in the base and a built-in leveling trough to aid you in installing the rain collector. The Rain Collector Heater is available for use with either of the Rain Collector units. This heater allows the Rain Collector to measure the moisture content of snowfall and protects the internal components from freezing rain. If mounted according to instructions, the Rain Collector is wind tunnel tested to be stable in winds up to 140 MPH (224 kph).


Sensor TypeTipping bucket with magnetic reed switch
Output Contact closure
Attached Cable Length 40' (12 m)
Cable Type 4-conductor, 26 AWG
Connector Modular connector (RJ-11)
Recommended Maximum Cable Length 900' (270 m)
Housing Material UV-stabilized ABS plastic
Dimensions :
Rain Collector 8.75" diameter x 9.5" high (16.5 cm diameter x 24 cm high)
Collection Area 33.2 in2 (214 cm2)
Weight 2 lbs. 3 oz. (1 kg)
0 vote