The Motor101A measures and records on and off status changes for motors or other equipment drawing up to 200 Amps. The state change occurs when the current switch exceeds the 150mA set point. This allows for most basic equipment to be monitored. The current switch monitors whether there is current passing through a wire around which it is clamped. When the current exceeds 150mA’s, the output changes and provides a voltage for the Motor101A to measure. The device can hold up to 406,323 state changes, but memory will only be used if the status has changed. The device can be programmed to check for status changes 4 times per second up to once every 24 hours
|
Amperage Range
|
0.15-200 Amps
|
|
Trip Point
|
0.15A (150mA) fixed (200mA AC for 50Hz operation)
|
|
Status Output (Max)
|
N.O. 1.0A@30VAC/DC
|
|
Huising
|
plit Core
|
|
Reading Rate
|
4Hz to 1 every 24 hours
|
|
Memory
|
406,323 readings; software configurable memory wrap
|
|
Wrap Around
|
Yes
|
|
Start Modes
|
406,323 readings; software configurable memory wrap
|
|
Multiple Start/stop Mode
|
Start and stop the device multiple times without having to download data or communicate with a PC
|
|
Multiple Start/stop Mode Activation
|
To start the device: Press and hold the pushbutton for 5 seconds, the green LED will flash during this time. The device has started logging
o stop the device: Press and hold the pushbutton for 5 seconds, the red LED will flash for three seconds and then the green LED will flash for two seconds. The device has stopped logging.
|
|
Real Time Recording
|
The device may be used with PC to monitor and record data in real-time
|
|
LED Funcionality
|
Green LED blinks: 10 second rate to indicate logging 15 second rate to indicate delay start mode
Red LED blinks: 10 second rate to indicate low battery and/or full memory
|
|
Password Protection
|
An optional password may be programmed into the device to restrict access to configuration options. Data may be read out without the password.
|
|
Engineering Units
|
Native measurement units can be scaled to dis-play measurement units of another type such as on/off, open/closed and more
|
|
Battery Type
|
3.6V lithium battery included; user replaceable
|
|
Battery Life
|
10 years typical, dependent upon frequency and duty cycle
|
|
Time Accuracy
|
±1 minute/month (at 20ºC/68ºF, stand alone data logging)
|
|
Computer Interface
|
USB (interface cable required); 115,200 baud
|
|
Software
|
XP SP3/Vista/Windows 7/Windows 8
|
|
Operating Environment
|
-15ºC to +40ºC (5ºF to +104ºF), 10%RH to 90%RH non-condensing
|
|
Dimensions
|
Data Logger: 1.4” x 2.2” x 0.6” (36mm x 56mm x 16mm)
Current Switch: 2.1” x 3.5” x 1.0” (54mm x 89mm x 26mm)
|
|
Weight
|
Without IFC200: 4oz (113g)
With IFC200: 9oz (255g)
|
|
Materials
|
ABS Plastic
|
|
Approvals
|
CE
|
BATTERY WARNING: FIRE, EXPLOSION, AND SEVERE BURN HAZARD. DO NOT SHORT CIRCUIT, CHARGE, FORCE OVER DISCHARGE, DISASSEMBLE, CRUSH, PENETRATE OR INCINERATE. BATTERY MAY LEAK OR EXPLODE IF HEATED ABOVE 80°C (176°F).
